made the i7 jump finally, heres what im running (its all in my sig anyways lol)

-I7 920 @ 4ghz d0 stepping
-ASUS P6T
-6 gigs ocz obsidian black ddr3-1600 @ 1950
-512mg XFX ati radeon 4770
-Coolermaster HAF 932
-coolermaster epower 600w psu
-swiftech Apogee GTZ water block
-swiftech 320 rad w/ 3x yateloons 120mm
-swiftech microres-2 reservoir
-Swiftech MCP655 pump
-WD 500 gig sata 2 hdd
-Windows 7 ult

pics added!
definitely kills my old e8400 lol

matt FAIL no pics

the res is filled thru a hole in the top, you cant see it to well but the triple rad with the yate loons is at the top of the case

i heat stretched the tubes onto bigger barbs, the zip ties is just because i could lol

that should provide for a good seal although i still don't trust zip ties or those snap clamps. especially since I upgraded to a i7 920, it'd be too expensive if anything went wrong lol

iv been thinking of redoing the whole setup soon, im still using the 775 hold down, thats why i went with the P6T, it had both the 1366 and 775 holes. but i plan to get a good board sometime after the new year so ill have to get the 1366 hold down regardless, i also want to tie the vid card into the loop

Just use mineral oil then, nothing's gonna short out, just everything gonna get covered in mineral oil seepage heh.

lol

i saw a video on the interwebs of someone submersion a mobo in oil and cooking smiley's , theres a hundred things wrong with that but amusing anyways lol

replaced the 4770 for a xfx gtx 260 maxcore 216 black edition